Stretch Wrap
"Stretch, Relax-Pallet Wrapping Made Easy" ^TM

HP 3200

PRODUCTION SPEED:

• 1-35 loads per hour

NOTE: Process rates will vary with load size, number of wraps & forklift load/unload time

LOAD CAPACITY AND TRANSFER:

• Maximum load weight: 5,000# dynamic - 15,000# static
• Maximum load size: 52" W x " 52" L x 82" H (73" Max. Load diagonal)
• Minimum load size: 30" W x 30" L x 24" H

TURNTABLE:

• 48" Octagonal 5/16" Thick Formed Plate Steel
• 5000# dynamic weight capacity
• 29" diameter ring gear support system, direct pinion-to-gear drive
• Turntable Height less than 13" from Floor
• Remote centralized lubrication for ring gear
• 1-15 RPM rotational speed c/w soft start acceleration and positive stop alignment
• 3/4 HP VDC Drive Motor, TEFC

FILM CARRIAGE ELEVATOR:

• 1/2 HP VDC variable speed motor
• ANSI # 40 direct chain drive c/w shock dampeners
• Maintenance free 12 point carriage guidance system

FILM DELIVERY SYSTEM:

• Saf-T Thread 20" capacity pre-stretch film carriage
• 1/2 HP VDC variable speed motor
• Fully electronic dynamic dancer corner compensation
• 110 to 313% fixed stretch capability (shipped fixed at 250%)
• Pre-stretch ratio variable by easy sprocket change
• Saf-T Thread" (Safety Door) with auto power cutoff switch

CONTROL FEATURES:

• Omron CPM1A Programmable Logic Controller
• Manual controls provided for turntable jog, film carriage elevator lower/raise, film clamp open/close
• Separate film carriage elevator raise & lower speed controls
• Film tension (force-to-load) control
• Separate top g, bottom wrap counters
• Auto load height detection photo-eye
• Illuminated power start- Emergency stop mushroom button
• Broken film/out of film detection c/w automatic machine reset and fault beacon light
• NEMA 12 control panel and junction boxes
• Non-proprietary UVCSA approved component
• Remote pendant start switch

AUTOMATION FEATURES:

• Pneumatically actuated film clamp mechanism
• Pneumatically actuated film tail cut/wiper arm mechanism
• Ni-chrome impulse hot wire film cut off c/w automatic periodic cleaning cycle

STRUCTURAL FEATURES:

• All structural steel construction
• Forklift truck portable base structure design
• Structural steel H beam machine tower
• ELECTRICAL INPUT REQUIREMENTS: o 115 Volts 1 Phase 60 Hz 20 Amps PNEUMATIC REQUIREMENTS:

ELECTRICAL INPUT REQUIREMENTS:

• 115 Volts 1 Phase 60 Hz 20 Amps

PNEUMATIC REQUIREMENTS:

• 3 CFM @ 80 PSI clean dry pneumatic supply required o Filter/regulator c/w gauge provided

<-- Go back to Stretch Machinery